The D2, 2 channel digital I/O expansion card, provides two I/O channels which can individually be configured as a digital input with latch or a high current sink digital output. Digital input and output functions can coexist.
The D2 has a built-in multidrop controller (
DS2406) which provides a unique 64 bit registration number (8-bit family code + 48 bit serial number + 8 bit CRC) assuring error-free selection and absolute identity; no two parts are alike. Unique addressing allows I/O function to be identified absolutely, no more dip switch address confusion. Status input, latched-input-activity and output-latch functions allow input, output and fast event catch functionality to hundreds of I/O points on a 1-Wire bus. The
DS2406 provides the digital I/O functions. The I/O connector is marked "A" I/O position one, "G" common ground returns, "B" I/O position two.
The D2 is designed to allow a network of input and output modules to operate on a two or three wire bus, power("+"), common("G") and data("D"). The D2 can be powered locally or the power may be bussed with the 1-Wire signal in a three wire system. The bussed power must be regulated 5V.
The D2 is compatible with any 1-Wire host with support for the Dallas Semiconductor
DS2406 Dual Addressable Switch.
Configurations
- D2 - no connector or pull-up resistor
- D2C - screw connector
- D2P - onboard pull-up resistor
- D2PC - screw connector and onboard pull-up resistor
Contact pads and without onboard pull-up resistor
Features
- 2 channels each configurable as either digital input, or digital output
- All data transfers are CRC16 error checked
- Digital outputs, (A) sink 50 mA, (B) sink 8 mA
- Digital inputs are latched until read
- Built-in multidrop controllers, (DS2406)
- CAT-5 twisted pair up to 1000 Feet, 100 devices
- Uses 1-Wire communication protocol
